• This is the combination of MEGA2560 + RAMPS1.4 + 5 x A4982 drivers (remix board)
• Using ATMEGA2560-16AU, and improve its performance highly.
• Support network function, then proceed remote control via IE Explorer.
• Up to 5 motor drivers with A4982
• Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board

Description :

• This is the combination of MEGA2560 + RAMPS1.4 + 5 x A4982 drivers (remix board)
• Firmware can use the same configuration as RAMPS1.4
• It is suitable for dual-Extrude printer
• Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
• 3x temperature ADC connectors for thermistors
• Up to 5 motor drivers with A4982
• 4x PWM capable power MOSFET outputs with voltage selector for MainPower.(Bed, Extruder0, Extruder1, Fans)
• 4 layers PCB, optimize heat dissipation.
• 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
• Recoverable fuse for short-circuit protection.
• USB Driver Chip FT232RL, you can get files from ftdi chip to setup driver: Ftdi-x86.zip
• Using professional power chip, support 12V-24V DC input.
• Good to work with 12864LCD and MKS TFT touch screen.
• Using A4982 stepper driver which supports 32-microstep and with excellent cooling.
• Currents of the stepper motor can be set directly, which can avoid the damage.
• Support highly modular open source firmware Smoothieware, easy for secondary development.

Package Included :

1 x 3D Printer Control Board MKS BASE V1.6 Board RepRap Ramps1.4 Compatible Development Board